www.esky-sh.com

Sorry the lcd is 4,3"

Hi all. I bought a S3C2440 with 4,7" lcd,I loaded a 7" Wince5 image and connected this board to a 7" lcd,but nothing is shown,the image is loaded ok because you can get access to the files with activesync, anybody can help me?

Thanks in advance

Hi again, I just tested an image from ftp,everything runs ok,great job¡¡¡
I would like to change the language to english,is there any way todo it?

Best Regards

Hi again, finally the Wince image is running in NANDFLASH, it seems the nboot.bin I was using was not working properly. Another issue is the ethernet connection, I can´t find in Wince where to configure it, when I connect the cable to a switch,the activity led is always off. I suppose the ethernet d...

Dear Sirs of esky-sh,I have required a ftp access to admin to download a 4,3" wince image.
But still with problems to start the Wince image from NANDFLASH.

Best Regards

Icaro600

Thanks alot esky-sh for your indications, the part of disconnect and connect again the usb cable,is as obvious that I forgot to do it. The image is loaded and started, I can surf to internet through the usb connection. I would like to note that I have not a Wince image for 4.3" in the CD, and neithe...

Dear Sirs of esky-sh, can somebody help me? You told me in email that post the problem,I did it, but still waiting. My project is stopped waiting for help.

regards

Icaro600

Hi all, I,m new in the forum and also in Wince and mini2440 development system, my board is a mini 2440 with 4,3" lcd. I have installed the image for linux qtopia from the CD,and everything is fine, but ethernet doesn´t works Later I have tried to install the Wince5 as follows: -Boot from Nor flash ...