www.esky-sh.com

• What is the address of the ftp server?

• What username and password do I use to access the ftp server?

Same here, FTP server is down and it's now 02/02/2013.

Do a google search for these books. You will find pdf's that you can download and read.

OReilly.Building.Embedded.Linux.Systems.Aug.2008.eBook-DDU

Building_bare-metal_ARM_with_GNU

buildroot-RMLL09

spraah2a.pdf

This last file is from TI (Texas Instruments)

Thank you for your continued patience in this matter. The problem has been resolved, I believe. At one point, I may have used a supervivi for 64 MB, instead of the supervivi for 128MB. I used the U-Boot at FreindlyArm and scrubbed the NAND and then created a new Bad Block Table. Using the correct su...

So the question that remains, after having reinstalled everything and then setting the jumper to NAND boot, why does supervivi not appear when K1 is held and the reset is pressed, then k1 released, then reset released? It just repeats the pattern with the clicking sound that I showed in my earlier p...

The buttons work! The problem is the huge number of bad memory locations. Please stay focused on the original complaint. There are numerous bad memory locations displayed while using the procedure in your pdf file to load the linux Operating System. The huge number of bad memory locations were not p...

OK, I should be able ot find that language menu again. Button 1, K1, you know what I mean. What is the problem with this board? Why is it all of a sudden displaying this huge collection of errors? Where is the source code or even a manual for supervivi? Can this board be made to work, or are you pre...

I set the jumper to nor, and when superviv was running, did the x (foramt nand for linux), v (load superviv), k (load Linux kernel) and then y (load toot)yaffs). I turned the power off. I switched the jumper to nand and then turned the power back on. It did the calibrate step, linux booted qtopia st...

I will do that on Manday as I am at home at this time.
I will respond at that time.
Regards, Richard

Where do I find this uboot to work with the board that I have?