www.esky-sh.com

Hi all,

I have successfully got the mini2440 running from NOR, but when I try to boot from NAND all I get is a very white screen, there is nothing from the console. I am assuming the board is not booting up any advise is welcome.

Board is a 256mb model with T35 lcd if this helps!

thanks in advance.

I have the same problem.

Linux and WINCE6 work in 256mb board but WINCE5 run just first time when the switch is in the NOR position.

I have 128mb and 1Gb boards and these boards don't have this problem with wince5.

you can use 'x', 'v' and 'w' command for wince installation on nand flash.