1. Copy BSP directory to your Platform Builder 6.0 BSP location
Normally PB 6.0 installation locates in C:\WinCE600, and BSP directory locates in C:\WinCE6.0\PLATFORM.
BSP directory for S3C6410 board is wince\platform
2. Copy wince/OSDesigns/tq6410 to C:\WinCE6.0\OSDesigns
Wince 6.0 -- Install BSP for S3C6410 board
Re: Wince 6.0 -- Install BSP for S3C6410 board
Hello
Now I removed all previous BPS and followed this instruction, boot and OS image works, almost ...
Touch Screen not working !
Buzzer Constantly on !
LCD Back-light can't be controlled !
Power-management not working !
Need some advise here.
Now I removed all previous BPS and followed this instruction, boot and OS image works, almost ...
Touch Screen not working !
Buzzer Constantly on !
LCD Back-light can't be controlled !
Power-management not working !
Need some advise here.
Re: Wince 6.0 -- Install BSP for S3C6410 board
Could you check what is in smdk6410.bat?dezso wrote:Hello
Now I removed all previous BPS and followed this instruction, boot and OS image works, almost ...
Touch Screen not working !
Buzzer Constantly on !
LCD Back-light can't be controlled !
Power-management not working !
Need some advise here.
It should be something like this:
set BSP_NOTOUCH=
set BSP_NOTOUCH_ADC=
set BSP_NOTOUCHCOM=1
set BSP_NOTOUCH_1WIRE=1
Who is online
Users browsing this forum: No registered users and 27 guests