Wince 6.0 -- Install BSP for S3C6410 board

Post Reply
esky-sh
Posts: 1435
Joined: Sat Dec 20, 2008 4:21 am

Wince 6.0 -- Install BSP for S3C6410 board

Post by esky-sh » Mon May 02, 2011 5:51 pm

1. Copy BSP directory to your Platform Builder 6.0 BSP location
Normally PB 6.0 installation locates in C:\WinCE600, and BSP directory locates in C:\WinCE6.0\PLATFORM.
BSP directory for S3C6410 board is wince\platform
2. Copy wince/OSDesigns/tq6410 to C:\WinCE6.0\OSDesigns

dezso
Posts: 65
Joined: Tue Mar 08, 2011 11:11 am

Re: Wince 6.0 -- Install BSP for S3C6410 board

Post by dezso » Tue May 03, 2011 4:51 am

Hello
Now I removed all previous BPS and followed this instruction, boot and OS image works, almost ...

Touch Screen not working !
Buzzer Constantly on !
LCD Back-light can't be controlled !
Power-management not working !

Need some advise here.

esky-sh
Posts: 1435
Joined: Sat Dec 20, 2008 4:21 am

Re: Wince 6.0 -- Install BSP for S3C6410 board

Post by esky-sh » Tue May 03, 2011 5:28 am

dezso wrote:Hello
Now I removed all previous BPS and followed this instruction, boot and OS image works, almost ...

Touch Screen not working !
Buzzer Constantly on !
LCD Back-light can't be controlled !
Power-management not working !

Need some advise here.
Could you check what is in smdk6410.bat?
It should be something like this:

set BSP_NOTOUCH=
set BSP_NOTOUCH_ADC=
set BSP_NOTOUCHCOM=1
set BSP_NOTOUCH_1WIRE=1

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest