Page 1 of 1
Pandaboard reworks of connecting to BeadaFrame display
Posted: Sun Nov 06, 2011 8:12 pm
by esky-sh
1. Add 33 ohm (0201) resistors on the back of the board (R176-R203)
Incase these are not available add zero ohm resistor or simply solder across the resistor pads.
2. Mount J1&J4 on back of the board
Actually solder them on top side.
Re: Pandaboard reworks of connecting to beada frame display
Posted: Sat Jun 16, 2012 6:29 am
by esky-sh
Pandaboard ES has a different schema(resistor array instead of resistor series) for LCD signal routing, than Original Pandaboard.
I will post an update for that soon.
Re: Pandaboard reworks of connecting to beada frame display
Posted: Sat Jun 16, 2012 7:50 pm
by esky-sh
This is all for pandaboard ES rev. B LCD hardware configuration.
- PANDA_ES_REVB.png (95.15 KiB) Viewed 6272 times
esky-sh wrote:Pandaboard ES has a different schema(resistor array instead of resistor series) for LCD signal routing, than Original Pandaboard.
I will post an update for that soon.
Re: Pandaboard reworks of connecting to beada frame display
Posted: Sat Jun 16, 2012 7:55 pm
by esky-sh
it should be on bottom. so you will need to remove the black plastic standoffs.
LARDEUR wrote:solder connectors J1 and J4 must be made on the top and bottom or only just bottom suffice?