Note:This procedures involve with Windows disk provision operation. Read this procedures first and ensure you understand thoroughly for each steps before real upgrade. Post questions here if you are not quite sure/clear for the steps in this procedures. Wrong operations may cause data lost and permanent damages to your PC hardware.
Section 1, Force into U Disk Mode
BeadaPanel firmware is resident in it's internal eMMC. We need force it into U Disk mode until we can access it from a Windows Host.
Pre-requirements
- A BeadaPanel Control Board
- A Windows PC Host
- DiskGenius Software https://www.diskgenius.com/download.php
- BeadaPanel Firmware Files
- Install DiskGenius on Windows host machine
- Connect Micro-USB cable with PC host and Innostick 6 P1
Firmware starts to run and LED1 starts to blink. - Mount Jumper J2-1 and J2-2 on Innostick 6(USB Memory Stick Mode)
Customer can use a tweezer or wire to short the two points together - Reset Control Board
Meanwhlie shorting J2-1 and J2-2, push RESET button to reset control board. You can release the shorter soon after you release the RESET button. - Wait until an USB mass storage gadget device recognized by Windows
There are Linux partitions on Innostick 6 on-board eMMC, Windows can not recognize them and prompt for formating
Select 'Cancel' in this case. - Double click to start DiskGenius.
BeadaPanel firmware residents in different eMMC partitions, so we should restore the partition table first. Procedures in this section are operated in DiskGenius.
- Click on the disk
- Right click to select "Restore Partition Table"
- Choose ptf file
- Click "Open"
- Click "Yes"
- DiskGenius ask if restore boot sectors, select "No"
- Partition table restore success
There are 4 partitions on BeadaPanel internal eMMC. We will copy firmware files to the first 2 partitions and format the last FAT32 partition.
Procedures in this section are operated in Windows resource explorer
- Find Windows disk letter for FAT16 partition, it is 'E' in this case.
- Open Window Resource Explorer and then open disk 'E'
- Replace these three firmware files.
Procedures in this section are operated in DiskGenius
- Click on First Linux EXT4 Partition
- Right click to select "Restore Partition From Image File"
- Select Image file
- Click "Open"
- Click "Start"
- Click "Ok"
- Provision start
- Provision complete
It may take about 3 minutes
- Click "Complete"
Procedures in this section are operated in DiskGenius
- Click on FAT32 partition
- Right click to select "Format Current Partition"
- Click "Format"
- Click "Yes"
- Format complete
- Choose the disk
- Right click to select "Safely Eject Disk"
- Re-plugin the USB cable and BeadaPanel will run into v7.10 firmware.
Procedures in this section are operated in Web browser
- Open web browser on Windows and enter "www.nxelec.com/service/beadatools"
- Click "Select screen"
- Choose target device
- Click "Connect"
- Connect success
- Click "Update firmware"
- Click "Remote update"
- Click "Update"
- Download start
- Inflate start
- Inflate complete, click "Reboot"
- Click "Confirm"