External controlled devices
Posted: Sat Jan 17, 2009 8:44 am
Hello,
Could you give me an advices about connecting external devices ?
As far as I understand assigned for this purpose are:
EINT0, EINT1, EINT2, EINT4, EINT5, EINT6, CLKOUT0 and CLKOUT1.
Is it correct that I can configure each of this GPIO as output or as input pin ?
Can I use another CON4 connector GPIO's dedicated for certain interfaces as GPIO ?
With best regards,
Mikhail.
Could you give me an advices about connecting external devices ?
As far as I understand assigned for this purpose are:
EINT0, EINT1, EINT2, EINT4, EINT5, EINT6, CLKOUT0 and CLKOUT1.
Is it correct that I can configure each of this GPIO as output or as input pin ?
Can I use another CON4 connector GPIO's dedicated for certain interfaces as GPIO ?
With best regards,
Mikhail.