www.esky-sh.com

Did u use -march=armv4t -mtune=arm920t for compilation of your file?

Hello Michel, so, I'm back again ;) I compiled your kernel, works great with uboot. Now im writing a helloworld.c, but the mini2440 cannot run it. Output is "nothing" whe executed via './hello' and "cannot exec binary file" whe doing 'sh hello' I have used these different crosscompilers and none of ...

Ok thank you for the fast reply, When using their kernel and config_N35 as .config, i cannot even start the kernel boot shows only uncompressingLinux....Done, and nothing happens (nevertheless,I'm pretty sure its my fault ;)) When using your kernel (patches), or the ones from Leshak (i understood yo...

Hi Michel, Great work doing and sharing this u-boot for mini2440. I just posted the site where i found it for downloading... but I'm afraid i didnt get your hint yet correctly: You need to use the kernel official board IDs for MINI2440 and QQ2440 Do i have to adapt the board type in kernel or in u-b...

Hello, thanks for the answer, ill dig a bit... Your Q regarding uBoot: Leshak (also active here) posted some nice tutorials regarding 2440: http://blog.leshak.ru/english/pages/how-to-install-u-boot-linux-2629-rootfsjffs2-busybox-1132-into-nand-qq2440/ uBoot 1.3.2: http://blog.leshak.ru/2009/02/25/ob...

Hello, hope somebody can give me a hint. I'm compiling kernel 2.6.29 for mini2440 (the one that was delivered with the update on 2009-04-15). Then, if i want to load kernel with uBoot 1.3.2 on mini2440, an error message occurs that ID is not known with following output: NAND read: device 0 offset 0x...

Hello,

great board!

Seems like the files are missing on ftp (only UM is there), images etc is empty...?

Thanks...