www.esky-sh.com

Hi.
When I connect USB camera to working board - it starts to work. But when camera is already connected and board is powered on - camera doesn't work. I need to pull it out from USB and connect again. Any advice would be appreciated. I'm using kernel 2.6.29 and debian.

Try driver "fbdev" in xorg config file. But you can't do much with xorg. With debian it leaves only 2 MB free memory. And it's so slow...

May be you should update supervivi to version provided with this release

I have found a nice tutorial about it http://en.wikibooks.org/wiki/QEMU/Networking

Hello.
How do you defined bridge? Can you post instructions?

Very strange. It freezes _before_ sending. I'm doing the same and everything is OK.

It seems like qemu can't start /etc/qemu_ifup because of permissions. Start qemu with sudo may be a solution. Or somehow permit qemu start script with sudo commands in it.

You should set up /etc/qemu-ifup file and bridge interface. Try to google for it.

It doesn't matter what you send first. Nboot and WinCE image have different areas in flash. For testing you can send only WinCE image and start it with supervivi (option -b)

I didn't understand your question.
Last mini2440 WinCE images works on qq2440 with new supervivi. And they run faster. You need to flash new supervivi with JTAG. After this any DNW should work (use option w). It freezes for 3-4 sec after downloading, but after this it works.