Incase these are not available add zero ohm resistor or simply solder across the resistor pads.
2. Mount J1&J4 on back of the board
Actually solder them on top side.
![Image](http://www.esky-sh.com/ebay_gallary/7frame/pandaboard_reworkn.jpg)
esky-sh wrote:Pandaboard ES has a different schema(resistor array instead of resistor series) for LCD signal routing, than Original Pandaboard.
I will post an update for that soon.
LARDEUR wrote:solder connectors J1 and J4 must be made on the top and bottom or only just bottom suffice?
Users browsing this forum: No registered users and 5 guests