Pandaboard reworks of connecting to BeadaFrame display

[esky-sh]

1. Add 33 ohm (0201) resistors on the back of the board (R176-R203)
Incase these are not available add zero ohm resistor or simply solder across the resistor pads.
2. Mount J1&J4 on back of the board
Actually solder them on top side.

[esky-sh]

Pandaboard ES has a different schema(resistor array instead of resistor series) for LCD signal routing, than Original Pandaboard.
I will post an update for that soon.

[esky-sh]

This is all for pandaboard ES rev. B LCD hardware configuration.

PANDA_ES_REVB.png (95.15 KiB) Viewed 22652 times

Pandaboard ES has a different schema(resistor array instead of resistor series) for LCD signal routing, than Original Pandaboard.
I will post an update for that soon.

[esky-sh]

it should be on bottom. so you will need to remove the black plastic standoffs.

solder connectors J1 and J4 must be made on the top and bottom or only just bottom suffice?